Plastics. Injection moulding of test specimens of thermoplastic materials - Determination of moulding shrinkageWhat is this standard about? This document specifies a method of determining the moulding shrinkage and post moulding shrinkage of injection moulded test specimens of thermoplastic material in the directions parallel to and normal to the direction of melt flow. For the determination of shrinkage of thermosets, see ISO 2577. Moulding shrinkage as defined in this document excludes the effects of humidity uptake. This is included in post moulding

Manufacturer or supplier of building products and components

long-term clinical experience of the use of the material referred to in the ISO 6474 series has shown that an acceptable level of biological response can be expected

both regional and international

2nd or 3rd family gases designed to operate in the condensing or non condensing mode for the heating of domestic dwellings or domestic dwellings in commercial premises by the circulation of heated water in open or closed systems

and having deviations from the target sizes corresponding to EN 336

The standard contains provisions for two grades

BS 8103-1 on the structural design of low-rise buildings is relevant to:

It contains the electrical test methods that are used for harmonized low voltage energy cables

All toys on sale in the UK must carry the CE mark

such as earthing of conductors

These dimensions also allow designs with a large eye which can permit direct connection with sling hooks of similar working load limit

5 Safety management: responsibilities of persons working on lifting platforms