End mill holder Weldon SK 50 - 32 - 80Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Note: From d = 25 on two clamping screws Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional

For sealing tools with internal cooling

Entirely hardened and grinded on the inside and outside

(without toolholders and inserts)

The steel body is hardened and grinded

Setting angle: 95°

ADJRGA = Length adjustment range

contact- and hot air shrink units

Applicable up to 100 bar

In this way

On machining centres without synchronised spindles

Wherever reduced interference contours are required

Coolant pressure up to 100 bar