1” Flange Bearing For Eliminator 224, Clipper M-2B & Clipper HoppersThis 1 flange bearing is used on the Eliminator and Clipper M 2B seed cleaners for the eccentric shaft mounting bearings. When replacing the old style mounting bearings on the clipper m 2b you must drill new holes to make this bearing fit. It can also be used on clipper hoppers. If it is used on the clipper hoppers it is not necessary to grease the bearings because the original bearings on clipper hopper were not greaseable. Clipper part number for M

These bearings are for the standard shaker conveyor that goes under many different Clipper grain and seed cleaners

5” wide and 4

It goes on the auger shaft behind the auger drive pulley

v=j5Bz-5LQN9w&t

The part number is F197-02901

This grain seal material is measured at 6 inches in width

It measures 1/2” inside diameter ¾” outside diameter

* all bearings & belts updated to standardized sizes and available locally

The part numbers are F030-16400

This pitman arm goes on the 68D and 69D models

This cable pulley assembly is used on both the Eliminator 224 & Clipper M-2B Seed Cleaners

If the pulley is on the left