GH1C-293-B 2-15/16" ID Black Oxide One Piece Clamping Shaft CollarDesign fully engages the shaft without marring. Recessed screw head provides safety with an outside surface free of major projections. Provides greater axial holding power than set screw collars. Effective on both hard and soft shafts. View Catalog Page

Provides greater axial holding power than set screw collars

-60° to 180° F temperature range

Pilot bore can be opened to the nominal ID reflected in the part number

View Catalog Page

Design fully engages the thread for secure locking

Bronze Bearing Type

Recessed screw head provides safety with an outside surface free of major projections

Traditional cost effective rigid coupling design

Allows you room to re-bore the ID without damaging the clamp screws

Two-piece stainless steel housing units

Bearing insert with 2 set screws has longer inner race for added load support

Easily installed where major disassembly would otherwise be required