Technical drawings. General principles of presentation - Basic conventions and applications for leader lines and reference lines1 Scope This part of ISO 128 specifies general rules on the presentation of leader and reference lines and their components as well as on the arrangement of instructions on or at leader lines in all kinds of technical documents.

in the case of grouted anchors

a maintenance plan shall be carefully prepared

albeit lower than that of activated carbon

Mislabelling or adulteration of cashmere products blended with other cheapest animal fibres such as sheep wool and yak have been repeatedly reported worldwide

Top management approval of the service management plan is important because the plan can have implications for commitments to the customer

It defines the properties that may need to be determined and the terms used in describing tests and test pieces

the burner and the boiler cannot become heated to create a hazard

This Part of BS 5499 specifies requirements for the construction and performance of a type of safety sign which is self-energized in respect of luminosity

Fatigue tests are performed to measure the reduction in stiffness and strength of materials under repeated loading and to determine the total number of load cycles to failure

(See next lines)

39 Common requirements for Category AP and Category APG equipment

ISO 16258-2 presents a method for analyzing respirable crystalline silica by X-ray diffraction using the indirect analysis method