Plastics piping systems. Polyolefin pipes and mechanical fitting assemblies. Test method for the resistance to end load (AREL test)1 Scope This International Standard specifies a method to determine, for mechanically jointed polyolefin pipe and fitting assemblies in sizes of dn 63 mm, the effect of component relaxation and creep on the resistance of the assembly to pipe pull out under the long term application of a constant and longitudinally applied force. The susceptibility of the polyolefin pipe to stress crack failure initiated by the joint assembly is also examined. NOTE For

Copper alloy ingots intended to be re-melted for later processing (e

PD CEN/TS 17303 describes a procedure for the identification of single fish and fish fillets to the level of genus or species

made from glass bonded mica powder

fertilizers

f) make a self-determination and declaration of conformance with this OHSAS specification

communities and business/service viability – additional measures might be necessary which are outside the scope of this British Standard

Civil engineers / construction engineers

BS EN BS CECC 63000 on the quality assessment of films and integrated circuits is useful for:

The BS EN 62075 standard covers only criteria directly related to the environmental performance of the product

BS EN 12371 contains provision for both a shorter technological test (Test A) to assess the effect of freeze/thaw cycles on the relevant performance characteristics and an identification test (Test B)

This standard applies also to ball valves in combination with other components in the same body

Business continuity consultants and auditors