C133E-212 Locking AssemblySingle taper, self centering design without mounting flange for use in through bored components. Mounted component moves axially during installation. View Catalog PageInstallation & Removal Instructions

Mounted component moves axially during installation

Traditional cost effective collar design

self-centering design with mounting flange for use in through-bored components

Click here for spec sheets: BUCNPFL Spec Sheet

Design fully engages the shaft without marring

USDA/FDA approved

self-centering design for use in through-bored components with extremely high torque and/or bending requirements

Self-lubricating ideal for wet or harsh environments where wash down is required

Effective on both hard and soft shafts

UHMW-PE provides durability & low friction

Climax Series C801 Single Nut Locking Assemblies deliver a mechanical interference fit and provides a higher torque capacity over alternative keyed connections

Easily installed where major disassembly would otherwise be required