Hydraulic fluid power. Flange connections with split or one-piece flange clamps and metric or inch screws - Flange connectors, ports and mounting surfaces for use at a pressure of 42 MPa (420 bar), DN 13 to DN 761 Scope This document gives general and dimensional specifications for flanged heads, split flange clamps (FCS and FCSM), one piece flange clamps (FC and FCM), ports and mounting surfaces applicable to four screw, split and one piece flange clamp type tube connectors and hose fittings for use at a pressure of 42 MPa (420 bar1). It also specifies the dimensions of the seals to be used, as well as the grooves that house the seals. This document also

The object is to establish and maintain the credibility of indicated data against influences acting to impair the fidelity of the system

Who is BS 1728-6 - Determination of iron by volumetric titanous chloride method for

the position of the mounting plane both relative to the front face of the connector

Note 1: BS EN IEC 62885-4 is applicable to measurements of the performance of cordless dry vacuum cleaners for household use or under conditions similar to those in households

Automatic forced draught burners for gaseous fuels

Secondary spatial ratios

FMECA) are out of the scope of this Technical Report

Type C non-load-limiting and load-limiting anchor systems (see 3

The temper designations used in BS EN 754-6 are according to EN 515

The information and technology industry

Ensure information risk is being adequately addressed

and ISO/IEC 17050‑1