Shrink chuck 4,5° HSK 50 - 16 - 95Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Matt chrome finish

low warpage hardened

Positive clamping due to penetration of the hardened claw tips

With securing screws and Tee-nuts

vertical and lateral

Ratchet stop

For mounting straight-shank tools and inclined flat according to DIN 1835 form E (Whistle Notch)

Dragged-in prism

Advantage:

Only nominal size d can be clamped

20 mm only with reduction sleeve)

Zero-setting at any position for incremental measurement