End mill holder Weldon HSK 63 - 32 - 110Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Chrome molybdenum steel ( or Chrome vanadium steel ) square drive

Stainless steel with surface hardened measuring faces

Setting angle: 107

The clamping screw incorporates a through hole

Bearing edge ground

Plug gauge sizes according to DIN 2245

All collets with outside form DIN 6388 (ISO 10897) can be clamped

precisionally grinded

For face machining

160 x 58 x 15

For mounting the coolant tubes in HSK toolholders

bei Ø 6 – Ø 32 mm = h238