SUCSP209-27 IP69K 1-11/16" Standard Duty Stainless Steel Set Screw Locking Pillow Block BearingClick here for spec sheet: SUCSP Spec Sheet

self-centering design with mounting flange for use in through-bored components with smaller pitch/outside diameters

Clamping coupling portion will not mar the shaft

Pilot bore can be opened to the nominal ID reflected in the part number

Entire unit is UHMW-PE

non-self-centering design for use in counter-bored components

Includes 2 rubber grommets to reduce vibration & noise

Provides greater axial holding power than set screw or one-piece clamping collars

USDA/FDA approved

Does not mar the shaft

Effective on both hard and soft shafts

Two-piece stainless steel housing units

high impact & abrasion