Blender LooperPlease note this is not a phrase or sample looper pedal where you can record your guitar and then play over the loops. This is a blender looper pedal that enables you to blend your dry signal with a parallel wet signal. For example if you have a delay in the pedal's loop you can use the level knobs to set the perfect level of delay and dry signal. The pedal has an active circuit which maintains the dry and wet signals, as well as a phase switch which

This is a dual AB switch that enables you to select between two inputs and outputs that are routed through the Send and Return sockets

Compatible with - TC Electronics Flashback 2

Both loops are individually activated by the front switches and you can reverse them using the rear switch

Cable required - Mono TS

however if you would like to power the LEDs you can add a battery to the internal clip or use the Boss style 2

The stubby 30mm high BOP Block risers are 20mm shorter in depth than the standard BOP Blocks

Size: 20mm(H)x170mm(W)x125mm(D)

You will need two mono cables to connect the pedal to your amp

one is a latching footswitch and the other is a soft touch momentary footswitch

53x38x31mm

Status LEDs

so switching one will not affect the status of the other loops