Spare Big Suck Bush TrackA spare brush track allows you to quickly change brush lengths of your Big Suck. Just remove the front collar, pull the track out, insert a new one and attach the new front. All parts are connected magnetically for a tool less swap of brushes.

ER11 – Air or Water Cooled

The mounting bracket has 20mm spaced M3 threaded holes for mounting accessories

Fully G-code controllable (PWM or Modbus)

Each run length needs to be approximately 6" longer than the axis it will support

⚠️ Some controller-specific items (like control cable or keypad mount) may be required depending on your setup

Route spindle power

Learn how they work in our KB guide »

Read full support policy →

There are also holes through the wings and base of the clip in case you want to run a zip tie all the way around the hose

💡 Looking for a lower cost alternative

This also allows you to temporarily remove the racks when you need to use the full width of the machine

Stay ready