End mill holder Weldon BT 40 - 06 - 50Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

In the tailstock of the lathe so that no friction between the workpiece and the tip occurs

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance5

Ideal für mittlere Werkzeugmaschinen mit vielen und schwer zu entfernenden Spähnen

102 x 45 x 15

For use on vises

it can be easily repaired at low cost

for clamping holders with coolant channels directly to the cutting edge

Spannkraft voreinstellbar durch Rillenmarkierung

Protection of the measuring unit takes centre stage

Excellent concentricity in the system (chuck + collet + clamping nut)

Metallic sealed Collets for internal cooling (applicable up to 100 bar)

For clamping nuts OZ-system