DSX IAT/Baro Breakout Harness w/Sensors, GenV LTDSX IAT Baro Breakout Harness, GenV LT The DSX IAT baro Breakout harness allows you to remove the IAT from the MAF assembly on newer vehicles so you can place it closer to the throttle for applications using methanol injection to meet fueling requirements. It also serves to break out the barometric pressure sensor, which allows the calibrator to restore proper calculations in the ECM for pressure ratio on boosted applications. IAT sensor and 3 bar MAP

Click here for installation instructions

5" Cat-Back + X-Pipe

Specifications Socket Size(s) 3/8 12pt

power and covered by our Lifetime Limited Warranty

The fibers are extremely uniform and very small

2L 1-7/8" x 3" Stainless Steel Long Tube Headers w/ 02 Extension Harness Kit (2 Front & 2 Rear)

5" Tubing After Muffler

but can be ordered with the larger connector hose for the Williams 102 TB

making it the perfect upgrade for both factory or aftermarket superchargers

You must use the longer shaft to be able to run our kit (they are not difficult to change)

Go with the proven cold air intake leader for the ZL1 since 2012

APPLICATIONS |