GH2C-212-B Two Piece Clamping Shaft CollarEasily installed where major disassembly would otherwise be required. Design fully engages the shaft without marring. Recessed screw head provides safety with an outside surface free of major projections. Provides greater axial holding power than set screw or one piece clamping collars. Effective on both hard and soft shafts. View Catalog Page

Porous flanged bronze bearing is press-fit in sturdy zinc die cast sphere with felt strip for lubrication

Provides torque transmission & alignment

Traditional cost effective collar design

Interchangeable with most metal units

Includes 2 rubber grommets to reduce vibration & noise

Includes 2 set screws

Self-lubricating ideal for wet or harsh environments where wash down is required

Extra thick non-conductive rubber liner corrects misalignment up to 2° while reducing noise & vibration

Two-piece stainless steel housing units

Easily installed where major disassembly would otherwise be required

high impact & abrasion

Acetal Copolymer collars will not rust or corrode