MAX487 low-power RS-485/RS422 Transceiver ICThe MAX487 is a low power transceiver for RS 485 and RS422 communication. One driver and one receiver are present in each component. The MAX487 has decreased slew rate drivers that reduce reflections from incorrectly terminated cables and limit EMI, enabling error free data transmission at speeds of up to 250kbps. MAX1487 is not limited, allowing them to transmit up to 2. 5Mbps. When empty or fully loaded with deactivated drivers, these transceivers

This cable is For Arduino UNO (USB A to B) that we can use to connect Arduino Uno or any board with the USB female A port of your computer

Isolation voltage between input and output

which has no deadband crossover distortion and a big output voltage swing

and the receiver output becomes low

Positive polarity symbol moulded on the plastic case

It has high efficiency and a high surge current capability of 500A

programmable watchdog timer with internal oscillator

The LED on the Receiver will flash once and then switch on

Brown for these 12K resistors

Centre hole fixing

Texas Instruments

Several innovative improvements have been added to the peak current mode control to allow primary side regulated CCM operation with no instability