Plastics. Determination of temperature of deflection under load - High-strength thermosetting laminates and long-fibre-reinforced plastics1 Scope This part of ISO 75 specifies a method for the determination of the temperature of deflection under load of high strength thermosetting laminates and compression moulded long fibre reinforced plastics in which the fibre length is greater than 7,5 mm. The flexural stress used is not fixed, as in ISO 752, but is a fraction (1 1 000) of the initial (room temperature) flexural modulus of the material under test. This allows the method to be

NOTE 1 CEN/TR 13737 contains:

Establishing management levels

virtual archives and museums and through other cooperative information systems

Woven Roving is widely used in hand lay-up

“The need for BS 8484 to help guide and advise employers of lone workers is more important now than ever

An unfired pressure vessel is any type of pressure vessel that is not fired

ISO 2026 specifies the dimensions of connectors for starting aircraft engines by air

BS EN 60154-1 also provides guidance on Mechanical requirements for mounted flanges

Note1: The testing method is referred to in EN 12081

helps the relevant sectors to get streamlined and organized

g)      The requirement for character references has been removed as this was seen to be too easy to abuse

self-learning software and weather forecasting systems