Jumper Wire (Male to Female)These are male to female jumper wires used in connecting the female header pin of any development board to other development boards having a male connector. They are simple wires that have connector pins at each end allowing them to be used to connect two points to each other. Jumper wires are typically used with breadboards and other prototyping tools in order to make it easy to change a circuit as needed. 40 strip Male to female jumper wire each

3V/5V securely fits in a typical 400 or 800 tie points breadboard

This button is ideal for simple on/off functions

Maximum RMS Voltage

Red is +5V

6A4 | Power Diode | Signal Diode | Silicon Rectifier | 6A4 Diode

The GPIO header remains the same

Resistance Value 330k ohm Color Code Orange

The intensity and dependability of this 12V Warm White 2835 LED Strip are very high

high-security isolation

High Count Rates - 42MHz

Internally Set Current Limit without a Current Sensing Resistor

JST 5 Pin Connector Plug 90 Degree